199-4521 1994521 Fahrantrieb für Caterpillar 322C Bagger

322C Final Drive for CAT Excavator spare parts 199‑4521 1994521 hydraulic motor reducer Aftermarket

Product Overview

The CAT 322C belongs to the C‑series generation that defined late‑90s and early‑2000s earthmoving — a 22‑ton machine that spent its working life on highways, subdivisions and pipeline jobs. Under each track frame sits the hydraulic motor and planetary reducer, references 199‑4521 and 1994521, that turns pump flow into the slow, steady pull moving the machine between pipe runs. These older Cats have clocked serious hours, and when the drive starts to tire the whole shift feels it: one track drifts on a long straight haul road, the track shell runs warm after a shorter trundle than it should, and a new whine creeps into the circuit under load. Most operators nurse it until a track hesitates on a grade — but by then the piston block and valve plate have already been lapping swarf into the oil. This aftermarket unit reproduces the original motor‑and‑reducer pairing as one sealed, test‑run assembly, so the worn drive lifts out whole and the new one bolts straight back in.

Core Advantages

1. Keeps a C‑series workhorse on the job
Original 199‑4521 drives for the 322C grow harder to source as the fleet ages. This aftermarket unit gives owners a path to keep a still‑useful machine earning rather than writing it off over a dead track.

2. Even track pull on long haul roads
A lapped piston block and valve plate hold pressure internally, so neither track lags. The machine tracks straight without the operator fighting a sideways tug.

3. Hardened gears for pipeline‑site shock
Pipe‑laying and roadwork throw ruts, curbs and broken ground at the drive. Case‑hardened planetary teeth absorb that load, and controlled backlash keeps the reducer quiet as hours climb.

4. Sealed against mud and dust of older‑site work
C‑series machines work through long days in clay, dust and standing water. Fresh shaft and housing seals keep that grit out of the lube — the protection that decides whether the drive reaches its next overhaul.

5. A direct, drop‑in fit
Flange, studs and ports reproduce the original, so removal and refitting follow the old CAT manual. No adapters, no fabrication, no guessing.

Manufacturing & Quality Control

Components are machined to the original drawing, heat‑treated where wear bites, and assembled in a clean area. Each finished drive runs on a hydraulic stand while torque, leakage and noise are checked; units outside tolerance are reworked before packing. The internals are fogged with preservation oil, ports are plugged, and the unit is crated on dunnage for freight.

Frequently Asked Questions

Q1: How do I confirm 199‑4521 matches my 322C?
A: Read the tag on your existing drive and send the machine serial number. CAT build variants across the C series can differ, so we cross‑check before dispatch.

Q2: Is this the complete drive?
A: Yes — the hydraulic motor and planetary reduction come as one bolt‑on assembly. The sprocket typically transfers over.

Q3: What symptoms mean the drive is tired?
A: Mismatched track speeds, pulling to one side, a warm or noisy track motor, and hesitation under load. Catch it before swarf spreads through the travel circuit.

Q4: What's the warranty position?
A: Materials and build defects are covered. Damage from dirty oil, debris in the motor, track obstruction, overload or incorrect fitting is excluded. Photograph any arrival damage before uncrating.